Manually adjust LED indicator brightness

Nokia Dial

  • 1. Press and hold the set button on the Dial for 3 seconds. It will beep and LED will start blinking green.
  • 2. Press and hold the set button again for 3 seconds. It beep and LED will start blinking red.
  • 3. Press and hold the set button on the Dial for 3 seconds. It will beep and LED stops flashing.
  • a. Adjust the brightness level by rotating the Dial clockwise to brighten, and counterclockwise to dim.
  • 4. Tap the set button once more to save the brightness level.

Nokia Paddle

  • 1. Press and hold the set button on the Paddle for 3 seconds. It will beep and LED will start blinking green.
  • 2. Press and hold the set button again for 3 seconds. It will beep and LED will start blinking red.
  • 3. Press and hold the set button on the controller switch for 3 seconds. It will beep and LED stops flashing.
  • a. Press and hold up or down on the Paddle to adjust the status LEDs brightness. Note that this will be the brightness level for the On state.
  • Tap the set button once more to save the brightness level.

    Nokia Keypad

    • Press and hold buttons 1 and 3 on the keypad for one second, then while still holding down the buttons, tap the set button and you should hear a beep.
    • Press and hold the 4th keypad button to brighten, then release and press and hold again to dim the LED, alternating between brightening and dimming until you reach the desired level.
    • Tap the set button once more to save the brightness level.

      Nokia Outlet

      The Outlet has two brightness options:

      Bright:

      • Turn on the top outlet so the LED is green.
      • Press and hold the top set button for 3 seconds until it beeps and flashes green, then release.
      • Press and hold the top set button again for 3 seconds until it beeps and flashes red, then release.
      • Press and hold the top set button one more time for 3 seconds until it beeps and has a solid bright green light, then release.
      • Tap the top set button one more time to set the LED to bright.

      Dim:

      • Turn off the top Outlet so the LED is red. 
      • Press and hold the top set button for 3 seconds until it beeps and flashes green, then release.
      • Press and hold the top set button again for 3 seconds until it beeps and flashes red, then release.
      • Press and hold the top set button one more time for 3 seconds until it beeps and has a solid dim red light, then release.
      • Tap the top set button one more time to set the LED to dim.